#!/bin/sh -e
# This script can be called in the following ways:
#
# After the package was installed:
#	<postinst> configure <old-version>
#
# After a trigger is activated:
#       <postinst> triggered <trigger-name>...
#
#
# If prerm fails during upgrade or fails on failed upgrade:
#	<old-postinst> abort-upgrade <new-version>
#
# If prerm fails during deconfiguration of a package:
#	<postinst> abort-deconfigure in-favour <new-package> <version>
#	           removing <old-package> <version>
#
# If prerm fails during replacement due to conflict:
#	<postinst> abort-remove in-favour <new-package> <version>


case "$1" in
    configure)
	;;

    triggered)
	# Force a reprofile
	if [ -f /var/lib/ureadahead/pack ]; then
	    echo "ureadahead will be reprofiled on next reboot"
	    rm -f /var/lib/ureadahead/pack /var/lib/ureadahead/*.pack
	fi
	;;

    abort-upgrade|abort-deconfigure|abort-remove)
	;;

    *)
	echo "$0 called with unknown argument \`$1'" 1>&2
	exit 1
	;;
esac

# Automatically added by dh_systemd_enable
# This will only remove masks created by d-s-h on package removal.
deb-systemd-helper unmask ureadahead.service >/dev/null || true

# was-enabled defaults to true, so new installations run enable.
if deb-systemd-helper --quiet was-enabled ureadahead.service; then
	# Enables the unit on first installation, creates new
	# symlinks on upgrades if the unit file has changed.
	deb-systemd-helper enable ureadahead.service >/dev/null || true
else
	# Update the statefile to add new symlinks (if any), which need to be
	# cleaned up on purge. Also remove old symlinks.
	deb-systemd-helper update-state ureadahead.service >/dev/null || true
fi
# End automatically added section
# Automatically added by dh_installinit
if [ "$1" = "configure" ] || [ "$1" = "abort-upgrade" ]; then
	if [ -x "/etc/init.d/ureadahead" ]; then
		update-rc.d ureadahead defaults >/dev/null || exit $?
	fi
fi
# End automatically added section

exit 0